JENOLITE Rust Converter Spray | 400ml | RUST TREATMENT & RUST INHIBITOR | Fast Acting Epoxy Based Rust Converter For Metal | Converts Rust Into Stable, Ready-to-Paint Surface

After a bit of research into what product was best for my needs, I opted for Jenolite Rust Converter Spray. Stone chips had broken through the paint around the arch areas of my campervan, looking unsightly. A quick rub down on the affected area with 80 grit oxide paper back to clean metal, masking tape applied to avoid any overspray, then follow the instructions on the can - shake contents for a few mins, then apply from around 25cms, leave to dry circa 15 mins, then re-apply. It's clear initially, but as it gets to work it turns black, after 2 coats a thick protective layer is formed, after fully dry / cured the epoxy feels tough and has good coverage, I'm letting it fully harden over this week, and will look to apply a top coat of colour matched spray paint, and clear lacquer top coat to blend it in, and will then apply 2 coats of the Jenolite on top of the colour matched spray paint for added protective layer as it is clear. Good product, good performance straight out the tin with minimal prep, instructions are simple to follow.

We have an old car that was starting to rust. It took a couple of applications but eventually worked. It dries to a matt black colour and since our car is black we’ve left it uncovered as it says you can as we are not precious about such an old car. You could spray over it tho if you choose. I did wear a mask, goggles and gloves also bought from Amazon as it says it’s quite toxic but I didn’t have any problems.

Seems good but only time will tell.

Easy to use and clear instructions. Dries quickly

This is a great product. I recently used it to treat the underbody of my 20 year old Ford Focus. It provided excellent coverage, and a good surface for paint to adhere to.However, as always with any type of paint/protector product, the preparation is every bit as important as the product itself. First, use a wire wheel and/or sandpaper to remove all the loose rust and dirt. Then use brake cleaner and a cloth to thoroughly clean and dry the area, and remove any grease. Only then should you apply the rust converter spray.Under these conditions, the spray adheres well to the surface, and forms an impenetrable epoxy barrier which stops rust developing further.Once this is dry, you can then paint it with the colour of your choice.

Seemed to do the trick on surface rust turning it to black after a scrub down.Time will tell how long lasting it is - hopefully a year.

OK product, but I thought it would turn the rust black which it doesn't seem to do. I wire brushed the surface rust off and when sprayed just went a bit darker. It does seem to protect it though so I gave it 3 coats.

Easy to use and dry quick. We use it to fix our car where were rusty.